Joint Lock Ring Technology Welded ID Wall Seal Type

In-Plant – Lock Ring Insertion Process

Joint Lock Ring is positioned into pipe end.

This completes the In-Plant Lock Ring Insertion Process.

The tool’s Press Plate is attached to the Clamp using 4 Bolts.

The 4 Bolts are tightened to press the ring into final position.

The same procedure is performed on the opposite end.

A 40' section of service pipe is first prepared by chamfering and sanding smooth the internal weld seam at both ends.

The assembly tool is clamped onto the end of the pipe.

A Welded Pressure Seal is applied to the pipe ID wall and the Joint Lock Ring.

This end of the service pipe receives a Joint Lock Ring with a flat, machined face.